OP-COM 1.99


OP-Com Description:

Opcom OP-Com Firmware V1.99 OBD2 DiagnosticTool with PIC18F458 Chip and FTDI Chip CAN cover almost for all Opel cars, even new cars with CAN-BUS based diagnostic, such as Vectra-C, Astra-H, Zafira-B.



Tuotetunnus (SKU): op-com Osasto: Avainsanat tuotteelle , ,


OBD2 OPCOM V1.99 Support Flash Update For Opel OP COM OP-COM With PIC18F458 Firmware V1.99 Auto Scan

Lähes kaikkiin opel autoihin, jopa uusiin joissa on CAN-BUS kuten Vectra-C, Astra-H, Zafira-B

Yksinkertainen ja helppo asennus windows xp tai windows 7 (32bit) pohjalle.


1. OP COM Interface
2. USB Cable
3. Software and Drivers CD

Suomenkielinen asennusohje tulee mukaan.


Jos tarvitset op-com softan niin sen voi ladata myös täältä

Asennusvideon löydät  Täältä

OP-Com V1.99 Highlights:

1. Language: English
2. Software Version: 120309a     Hardware Version: 1.99
3. OP-COM – PC based Opel diagnostic tool, work on Opel till the year 2014
4. With PIC18F458 Chip, work more stable
5. It can work on both Windows XP and 7 now

OPCOM V1.99 Function:

1. It covers almost all Opel cars, even new cars with CAN-BUS based diagnostic, such as Vectra-C, Astra-H, Zafira-B.
2. The program lets you read out and clear fault codes, shows you live data, lets you perform output test.
3. The program supports many control units, like Engine, Automatic Transmission, ABS, Airbag, Engine Cooling module, Instrument Cluster, Electronic Climate Control, Body Control Unit, just to name a few examples.
4. Since Opel uses many pins in the OBD connector, the diagnostic interface works as a multiplexer and selects the appropriate pin for communication.
PIN3, PIN7, PIN8, PIN12 = Serial Link (ISO9141, KW81, KW82, KWP2000)
5. Fault codes will be shown with all available information:
Full fault code text description:
1) Full status information (Present, Not present, Intermittent)
2) You can print out, save, or copy the fault codes to any other application. From the fault codes window, you can go directly to the measuring blocks window.
3) The program shows you measuring block information on many control module, you can choose anything from the list on your own.
4) The program is capable of showing 8 measuring block parameter simultaneously. The sample rate depends mostly on the communication protocol. For example, older system, like Omega-B X 25 DT Engine (ISO-9141-2) can be very slow, during communication, while newer Multec, or Bosch units are faster (using KWP-2000), and the newest CAN based control units are very fast!

You can also run output tests on many controllers.

HSCAN – Dual-wire, High-Speed CAN-BUS, 500 kbps
MSCAN – Dual-wire, Medium Speed CAN-BUS, 95 kbps
SWCAN – Single-wire, Low-Speed CAN-BUS, 33.3 kbps


Tuotearvioita ei vielä ole.

Kirjoita ensimmäinen arvio tuotteelle “OP-COM 1.99”

Sähköpostiosoitettasi ei julkaista. Pakolliset kentät on merkitty *